Recently in Ailerons Category
Pop riveted the rod ends to the internally/externally primed control rods.
The same process as the W-821's. You can detect some light corrosion on
these items so a vigorous priming session is now the early order of the
day!
Continue reading W-824 Aileron Gap Seal drillouts.
Phew! at last this is done. I've been worried about this for some time as it's a lot of drilling 'non prepunched holes' and also many builders have had edge distance issues. See next entry how things were in this regard........
I used a 1/4" bolt to provide for the minimum specified clearance between aileron and flap.
Trailing edge alignment was achieved using a straight edge against the aileron (r/h/s) and extended along the flap and secured with the use of 1" mini clamps.
