Flap Motor installation

| | Comments (0) | TrackBacks (0)
59-lll12 002.jpg








Note: I used a piece of .125 to keep the weldment off of the F-831 as specified in the plans.

0 TrackBacks

Listed below are links to blogs that reference this entry: Flap Motor installation.

TrackBack URL for this entry: http://carringtonw4.net/cgi-bin/mt/mt-tb.cgi/292

Leave a comment

About this Entry

This page contains a single entry by Levrie published on September 12, 2008 10:14 PM.

Floor nutplate preparation was the previous entry in this blog.

Fuselage: Rear parcel area is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Powered by Movable Type 4.1