Van's builder support

By Levrie on October 17, 2007 4:45 PM | | Comments (0) | TrackBacks (0)

Spoke with Ken at Van's this afternoon to clarify that my Aileron Gap Fairing installation is OK? It is.
No drawings are available for this part with the earlier kits supplied and it's a little bit of trial and error!
In fact, he said that I could "chop the end's off up to the doubler plates if you wanted to as it's not such an important part of the structure but I would'nt bother with that either". Great, I can move on.

The newer AGFs are pre punched and illustrated appropriately too!

Categories:

0 TrackBacks

Listed below are links to blogs that reference this entry: Van's builder support.

TrackBack URL for this entry: http://carringtonw4.net/cgi-bin/mt/mt-tb.cgi/272

Leave a comment

About this Entry

This page contains a single entry by Levrie published on October 17, 2007 4:45 PM.

W-824 Aileron Gap Seal (Left) was the previous entry in this blog.

Flap Brace R/H W-821 is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Powered by Movable Type 4.1

Search