Rudder Horn

| | Comments (0) | TrackBacks (0)

Paris_08FEB07%20046.jpg
I used solid -3 rivets, although the most extreme corners I hashed up and had to drill out to -4's. The result was good but ..... is it worth all the hassle?

0 TrackBacks

Listed below are links to blogs that reference this entry: Rudder Horn.

TrackBack URL for this entry: http://carringtonw4.net/cgi-bin/mt/mt-tb.cgi/207

Leave a comment

About this Entry

This page contains a single entry by Levrie published on December 5, 2006 11:00 AM.

Rudder Horn assembly (rear spar, rib & horn) was the previous entry in this blog.

Rudder Stiffner dampening is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Powered by Movable Type 4.1